How To Perform Daily Maintenance And Care On The Hose Filling And Sealing Mac...

Daily maintenance and care of the hose filling and sealing machine is the key to ensure its stable operation and extend its service life. Here are some specific maintenance and care suggestions:

1. Daily cleaning

Cleaning of the working area: Before and after using the equipment, ensure that the working area is clean to prevent contaminants from entering the equipment. Clean and disinfect the working area of ​​the equipment in time to prevent contaminants from remaining.

Cleaning of the machine surface: After use, attention should be paid to timely cleaning of the machine surface and surrounding areas, including the hose, conveyor belt, and related transmission parts on the baler. Compressed air can be used to clean the inside of the machine to remove dust and dust.

Cleaning of the sealing ring: Clean the sealing ring of the machine regularly, and be careful not to wet other parts.

2. Lubrication and maintenance

Select lubricant: Select suitable mechanical oil and grease according to the model of the equipment and the manufacturer's recommendations.

Lubrication parts:

The needle bearing on the clamp rod, the radial bearing supporting the clamp rod, and all rotating and sliding parts need to be regularly filled with grease or other lubricants.

The grease of the large plate column sleeve and the various parts of the indexing mechanism needs to be replaced regularly, and the oil injection should be checked once a week.

The reducer needs to be lubricated according to the instruction manual of the reducer manufacturer.

The main transmission system located at the bottom of the machine, including the chain, all cams, eccentric wheels and other rotating and sliding parts, needs to be lubricated regularly.

3. Parts inspection and replacement

Regular inspection: Regularly check the failure and wear of various components, including rubber seals, conveyor belts, motors, etc. Check whether the hose is cracked or aged, and replace it in time if necessary.

Use original parts: To ensure that the machine runs in an efficient and safe state, please use original parts for replacement.

4. Electrical system inspection

Switch inspection: During operation, regularly check whether the electrical switches are sensitive and regularly replace damaged electrical components.

Power supply inspection: Use a single-phase three-wire power cord and ensure that the floor of the workplace is dry to maintain insulation. Before turning on the power, the induction aviation plug must be inserted and the screws must be tightened.